HARLEY DAVIDSON CRESTED BAR AND SHIELD PASSENGER FOOTBOARD KIT REMOVAL AND INSTALLATION MANUAL

download
REMOVAL 1. See Figure 1. Remove existing passenger footpegs and mounting hardware. 2. Remove chrome swingarm pivot covers, if equipped. 3. Do not remove tool boxes, if equipped. INSTALLATION NOTES To prevent damage to chrome surfaces, avoid contact with abrasive materials (stones, sand, etc.). Some paint removal from counterbore holes of footboard brackets may be necessary to ease the installation of the pivot pins. Install Left Footboard Mount and Bracket 1. See Figure 2. Position left footboard mount (1) and insert screw (2) through mount and into footpeg mounting hole. 2. Position semi-circular cutout in mount extending from side of mount around nut of swingarm pivot bolt. Tighten screw (2) to 35-45 ft-lbs (47-61 Nm). 3. Position left footboard bracket (3) on mounting stud so that bolt hole aligns with machined groove in stud. 4. Insert screw (4) through left side in split hub of footboard bracket. Thread into tapped hole (right side) of split hub. Tighten to 10 ft-lbs (13.6 Nm). Install Right Footboard Bracket 1. See Figure 2. Position right footboard bracket (5) onto muffler support bracket. 2. Secure footboard bracket with screw (6). Tighten to 35-45 ft-lbs (47-61 Nm). Install Left and Right Footboards NOTE The footboards are side specific. Install footboards with Bar and Shield logo toward the front. 1. See Figure 2. Place footboard pad (7, 8) on footboard bottom (9, 10) and thread the pivot pins (11, 12). 2. Tighten pivot pins to 60-68 in-lbs (6.8-9.0 Nm). 3. Place spring (13) into retaining hole in footboard bracket (3, 5). Rest Delrin® ball (14) on top of spring. 4. Position footboard bottom (9, 10) onto footboard bracket in the down position while being careful not to unseat the ball. 5. Tighten pivot pins to 12-15 ft-lbs (16.3-20 Nm). 6. Press down on footboard assembly so holes align. 7. Insert mounting pins (15) in footboard bottom (9, 10) into corresponding holes in footboard pad (7, 8).